Polar Seal is a protective coating that has been specially formulated for application through a pressure washer with a foam gun. It imparts a hydrophobic layer onto paintwork that causes water to bead on the surface, which reduces the time it takes to dry the car. Simply spray diluted solution onto a clean, wet vehicle, rinse off and dry to leave behind a high gloss finish.
It is recommended that you pre-wash the vehicle, using Autoglym Polar Blast followed with Polar Wash to remove any dirt or contamination on your paintwork is ideal.
Only a small amount of Polar Seal is required. Pour no more than 40ml (four capfuls) into your foam bottle and then add at least 200ml of water. This should be all the finished solution required to cover your vehicle. There is no benefit in using any more than 40ml as over application can compromise the finish.
Spray Polar Seal onto the clean, wet vehicle, ensuring all exterior surfaces are covered, although avoid direct application to the windscreen.
Thoroughly rinse and dry your car to reveal a high-gloss finish that is protected with a hydrophobic coating. The car must be dried with a cloth and not allowed to air dry as water spotting may occur.
For the optimum finish, dry with the Autoglym InstaDry cloth.
You can also use Autoglym Fast Glass to clean the windscreen and wiper blades to ensure no smearing occurs.
Applying Polar Seal more than once a month is not recommended.
Polar Seal is not suitable for use on soft top convertibles.
Do not store diluted product. Please rinse foam bottle and pressure washer lance after use.